CUSTOM MEASUREMENTS GARMENT SPECIFICATION

BUILT TO
YOUR SPECIFICATION.

Enter your garment measurements using the technical guide below. Each measurement corresponds to a specific point on the garment.

  1. 01 Specification Measure the garment and enter each value.
  2. 02 Review Check every value before sending.
  3. 03 Delivery Send the completed specification to ROOTS.

Measurement workspace

Technical flatShirt / Front Fig. 01Not to scale
Technical flat drawing of a shirt, front view, with measurement indicators A symmetrical line drawing of a long-sleeved shirt laid flat, showing the collar, collar band, shoulder seams, set-in sleeves with cuffs, front placket with buttons, side seams and straight hem. Dimension lines mark chest width, shoulder length from the collar corner, sleeve length, body length, hem width, bicep, cuff opening, neck width and collar height. Each measurement is also listed as a labelled input field in the form beside this drawing, where the same values can be read and entered. CHEST WIDTH SHOULDER SLEEVE LENGTH BODY LENGTH HEM WIDTH BICEP CUFF NECK WIDTH COLLAR HEIGHT
Garment outline & seams Measurement indicator Active measurement

Fields marked * are required. Measurements marked PENDING are awaiting confirmation of the ROOTS specification and can be left blank.

A Garment information

The technical drawing shown is a shirt. For any other garment, use the closest equivalent points and describe anything specific in the production notes below.

Measurement unit *

Switching the unit converts any values already entered.

B Body
C Sleeves
D Collar
E Who is sending this

MEASUREMENT NOTES

HOW TO MEASURE.

  1. 01

    Lay the garment flat

    Place the garment face up on a hard, flat surface. Smooth out folds without stretching the fabric. Fasten the placket and align the side seams.

  2. 02

    Measure edge to edge

    All widths on this page are flat measurements taken from edge to edge in a straight line, not around the body. Do not double the value.

  3. 03

    Keep the tape square

    Hold the tape parallel to the surface and perpendicular to the seam being measured. Record to one decimal place.

  4. 04

    Send a reference garment where possible

    A physical reference garment removes ambiguity. Note in the production notes if one is being couriered to the Bangalore facility.

Measurements marked PENDING are optional. If you are unsure of a value, leave it blank and add a note below — we will confirm it with you before production.